1. Which mechanism must be chosen to optimize the reconvergence time for OSPF at company location 408817202 that is less CPU-intensive than reducing the hello and dead timers?

2. A network administrator is troubleshooting a high utilization issue on the route processor of a router that was reported by NMS. The administrator logged into the router to check the control plane policing and observed that the BGP process is dropping a high number of routing packets and causing thousands of routes to recalculate frequently.
Which solution resolves this issue?

3. What is an advantage of using BFD?

4. An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table.
What should be configured to accomplish this task?

5. When determining if a system is capable of support, what is the minimum time spacing required for a BFD control packet to receive once a control packet is arrived?

6. An engineer configured two routers connected to two different service providers using BGP with default attributes. One of the links is presenting high delay, which causes slowness in the network.
Which BGP attribute must the engineer configure to avoid using the high-delay ISP link if the second ISP link is up?

7. An engineer configured policy-based routing for a destination IP address that does not exist in the routing table.
How is the packet treated through the policy for configuring the set ip default next-hop command?

8. Which configuration enables the VRF that is labeled `Inet` on FastEthernet0/0?

9. Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

10. Which command displays the IP routing table information that is associated with VRF-Lite?

11. Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

12. R2 has a locally originated prefix 192.168.130.0/24 and has these configurations:

What is the result when the route-map OUT command is applied toward an eBGP neighbor R1 (1.1.1.1) by using the neighbor 1.1.1.1 route-map OUT out command?

13. Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?

14. What is a prerequisite for configuring BFD?

15. An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency. The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE.
Which action should be taken to resolve this issue?